So here's an update. I ordered a carb kit off of ebay and I cleaned and rebuilt carb. I soaked it in solution overnight and then rinsed with water. I then blew out all passages with compressed air. Put it all back together and it only runs on full choke (when it runs that is). Using carb cleaner to start produces mixed results. Sometimes it starts the engine, and sometimes it doesn't. So I took it apart again and adjusted the float according to spec in the Wisconsin service manual (1-5/32 inches) and cleaned everything out again with spray carb cleaner and more compressed air. Put it all back together - but still same result - won't start easily, and when it does start, will only run on full choke. In fact I have to HOLD the choke lever in place at full choke, otherwise it will move on its own and stall.
Also the glass fuel sediment bowl strainer under the tank won't fill up when I tighten the fuel lines. I also replaced that part as well - a brand new sediment bowl. Just for kicks I put the old bowl back and it too won't fill. Only when I loosen the fuel line somewhere and let air in the line will it fill the bowl.
I have taken this carb apart 3 times (including to rebuild it) and did the same thing each time: sprayed carb cleaner in all ports and passageways and then used compressed air. I've tried adjusting the two adjustment screws (the idle screw on top and the high speed screw on the bottom side). I don't know what else to do. I can take this thing apart a hundred times and still have the same result. What could be the problem?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
