Posted by Kirk Grau on March 03, 2012 at 17:15:16 from (98.235.64.137):
In Reply to: Floor Progress (pic) posted by in-too-deep on March 03, 2012 at 16:18:23:
As much as you can tell from the picture it looks like you might have a pretty solid floor under there. I might go ahead and rent a drum sander and see what it does on the other half, but probably would not be overly optimistic. Seems about 50-50 to whether or not it will work.
As somebody else noted, go ahead and remove the baseboard. It is going to need to come off eventually to sand the floor. When you go for the drum sander inquire if they have an edge sander as well. Job goes pretty quick with the right tools. When sanding just remember to keep that puppy moving, can make a really nice groove in the floor in seconds if left to sit still.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.