Posted by Texasmark1 on February 24, 2012 at 06:19:54 from (67.142.164.23):
I noticed you answered my "pun" remarks about the alcohol produced for ethanol getting side tracked.
In your answer you said that it had been available in your area for 25 years.
I have had something happen in my fuel line on my boat, which could very well have been caused in the fuel line on a tractor that has me stumped.
Between the tank and the engine I am using a grey silicon OEM Mercury fuel line with an OEM squeeze priming bulb and it is about 5' long; some vertical runs and a short length lies flat after it comes out of the tank. It is slick on both the inside and the outside, and upon examination, had not deteriorated on the inside. The tank is Crosslinked polyethylene built by Moller (spelling); apparently a figure in the business.
I recently had my fuel line plugged with somewhat soft, caramel colored particles, that had a circular back side, the same shape as the inside of my 5/16" line. They were about 1/8" square and were individual but packed most of the line.
The line is 10 years old, gets fresh gas with a little Sea Foam often enough to stay fresh. Ethanol hasn't been introduced around here till the last couple of years and I never had this problem before......but it could have been developing during that time. The inside and contents of the tank are pristine clean. The fuel outlet is covered with a fine mesh screen
Have you or any of your friends/associates had anything like that in any of your fuel lines in that 25 years of availability in your area you mentioned?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.