Posted by Mtjohnso on December 16, 2011 at 14:51:05 from (134.134.139.72):
I am planning on rebuilding my old barn this summer and also build a storage shed for the equipment. There are a lot of pole buildings going in around here as there are in other places in the country. I see most dig a hole, put the 8x8 post in and then pour concrete around the post. I assume the 8x8 is pressure treated. How long is a post like this good for before it rots off? I live in Washington on the west side, so it it a bit wetter here than in other places and I worry about the post rotting off. I had thought about taking the 8x8 posts and secure them to concrete footings using the metal shoes that you can purchase at Home Depot and other places. Maybe dig the same hole, fill with concrete and put int the metal shoe to hold the post. My dads old barn that lasted for 50 years just had conrete pads 2 ft x 2 ft x 4 or 6 inchs thick that the main posts in the barn sat on. The barn stood up under some pretty heavy winds a earth quake or two. The barn not having the shakes replaced on it finally did the old barn in. Thoughts on barn building and post installation?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
