Posted by Rich_WI on November 02, 2011 at 17:46:47 from (50.50.123.216):
In Reply to: Wisconsin posters. posted by Spotted Horse on November 02, 2011 at 13:12:04:
Quoting Removed, click Modern View to see
Thats correct but the point of the Utah permit isnt to take the place of a WI permit, its to allow you to carry in as many states as possable. If you hold a Utah permit, a large number of other states will recognize it and allow you to carry in those states as well. Besides, if you have the training that will allow you to get a Utah permit, that same training will allow you to get a WI permit. So if you are a WI resident with a Utah permit, you now apply for a WI permit and then you should be good to go in all but 15 of the 50 states.
Here is Utah's webpage with some more info. http://publicsafety.utah.gov/bci/FAQother.html
Quite a few of the people I know are going the Utah route but they are mostly older and travel quite a bit or have parents in FL or AZ so it makes sense.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
