Posted by Yesterday'sRick on November 01, 2011 at 19:05:29 from (209.91.107.179):
1964 JD 4020 was running just fine and had stopped and started it a few times thoughout the day and now when I turn the key on the little red generator (24 V)light comes on full intensity as it should however when I turn the key to start nothing happens, selenoid doesn"t engage or anything. Previously had a connection problem at transmission gear position switch however doesn"t seem to be a problem. I assume it is just a open/close switch but not sure if the permissive is open or closed. Tried disconnecting it with no luck, tried jumpering wire with no luck. Did same for the clutch engagement switch as well also no luck. Can anyone confirm that these are simple open/close switches and if not how can you check them? Also are there any other start permissive switches that anyone is aware of? Thank you in advance for any ideas. P.S. If your response is "get a manual", save your breath.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.