Posted by dave2 on October 03, 2011 at 00:43:02 from (139.139.35.70):
Hey,
What do you (or the boss) have in mind for horses? Already got something picked out or are you shopping?
As for the fence, I'd love to have HT but it's considered a permanent fixture here and can't be used outside town limits (even on your own property :roll: ).
If you don't want to clutter up the whole fence with flags or tape, just block off a corner 60 feet or so, flag it, and put some goodies on the fence to get them (horses) a good jolt or 2 then leave them alone a day or so/turn them out.
If they are freaks, no amount of flags is going to change it.....
Now, for some unsolicited advice.....Stay away from rescues, retired race horses, and anything that someone tries to use your soft side to unload on you...... Horses are usually cheap for a reason also. If you want something just to ride/enjoy, pick up a couple of draft horses or foundation bred quarterhorses or appaloosa's. Don't get a cutter, reiner, or halter horse (unless that's the direction you want to go). And enjoy a ride when you feel like throwing a saddle on (or not) without having to lunge/warm up (work the kinks out) for half an hour first.
And, above all else, lean to wade thru/weed out "expert" advice......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.