Posted by Tech 7 on September 23, 2011 at 07:57:58 from (206.47.90.66):
Posted this on the Case forum a few days back but didn't get any response so here I am; have rolled the engine to #1 TDC compression,mark on flywheel is visible through plug hole in bell housing,turned mag until it snaps at #1. This is a Case mag I believe and has a pointer indicating which tower is being fired. Then bolted mag in place and towed.It will fire,late I think as we can get flame out the exhaust when I tweak the run/start lever on the back of the mag.I narrowed the points up a bit but this did not change anything. Went through the above steps several times,including hand cranking and watching the valves/spark relationship which appears close. Finally called it a day shortly after mid night and drove home (an hours drive) so don't feel to brilliant today. Any help with this issue (the tractor,not me!) would be appreciated, Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.