Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: OT wire question


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by John T on August 27, 2011 at 06:22:08 from (63.252.228.254):

In Reply to: OT wire question posted by DanR on August 27, 2011 at 05:18:00:

Of course direct bury UF is easy, just dig a trench n bury the cable. HOWEVER I'm like Mark, if you bury conduit then snake the cable (USE or THWN, I forget????) through youre better protected and can upgrade sooooooo much easier. I wouldnt run any less then 100 amps of service (No 1 copper should allow for voltage drop) or at least use big enought conduit and wire so that much could be supplied if and when needeed. Id use rigid conduit risers where the underground conduit rises up above the ground (or under driveways) and LB's into your building.

For 120/240 volt single phase 3 wire serive, run 2 Hots (L1 & L2),,,,,1 Neutral (a GrounDED conductor),,,,,,,1 Equipment GroundING conductor) and at the remote buildings panel DO NOTTTTTTTTTTT bond the Neutral and Equipment Ground Busses together (keep isolated i.e. need a panel that allows for such) like is done at the main service entrance. Of course each buildings service still requires adequate earth grounding such as made grounding electrodes like driven copper rod or rods or metallic water pipe etc etc.

Its not that bad of a job to bury plastic pipe and the wire wont be much more expensvive then Underground Feeder UF and with 100 amp rated conductors or bigger to allow for voltage drop (if youre not going over 100) then youre set for life

Leavin Half Century of Progress in Ilinois headed for Ohio today

John T


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

Advanced Posting Options

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.



 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle? ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy