Posted by notjustair on August 03, 2011 at 12:06:52 from (174.253.131.167):
We've had a cool wave (it's only 100) so I thought I would put the Horn-draulic loader on the Farmall M. I got it when I got the tractor but have no idea when it was last on or used.
It went on OK but one of the cylinders is stuck. They were both about half extended and that one will not extend or retract (gravity). The other works just fine (there is one hydraulic line with a T in it at the bottom of the stuck cylinder). I pulled the vent plug and there was a bit of air whoosh out, but that was it. I tried beating on it, working the loader up and down with the other cylinder, etc. I'm sure it will have to be rebuilt, but how do I get it unstuck to see?
Can I put some penetrant of some kind down the vent hole? Do I take it off and pull it apart with the tractors?
The ram is in the cylinder straight, it isn't bent, and it looks really good through the vent plug hole.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.