Tool Talk Discussion Board |
Re: Re: DIY case hardening
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig on January 11, 2004 at 16:41:30 from (155.92.111.99):
In Reply to: Re: DIY case hardening posted by D.L. on January 11, 2004 at 11:45:59:
Thanks for all of the responses. I'm going to try that charcoal thing just because it sounds really neat. I have one question though. putting a red hot piece of steel into charcoal will surely light it on fire. Im guesing i will need to bury the part under enough of this crushed charcoal to block the oxygen from getting to it. the question is how far do i have to bury it? or do i just do the whole thing in a pot and put a lid on to keep the oxygen out? i'm just going to try a small piece of angle iron since it is an experiment.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|