Tool Talk Discussion Board |
Re: Re: Chicago Electric Power Tools . are they an
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rb on August 11, 2003 at 10:27:32 from (65.58.152.17):
In Reply to: Re: Chicago Electric Power Tools . are they any good? posted by wjc on April 03, 2003 at 18:51:12:
We bought a 3lb. tumbler that barely made it through one run. During the polishing the belt broke. You are suppose to oil the bearings and needless to say the oil worked itself into the rubber roller and would no longer roll. We took it apart to fix the problem and found that all the covers or washers over the bearings were torn and desinigrating after one run. I finished my run with a vibratory method using my husbands brass cleaning equipment. I would not recommend this method for rounding rocks in the grind cycles but more for polishing. We spent more time fixing the unit than using it. Looking for a better one!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|