Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Garden Tractors Discussion Board

Re: JD 111 won't pick up load cold


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by lee on November 24, 2004 at 13:30:07 from (24.24.95.246):

In Reply to: JD 111 won't pick up load cold posted by leon on November 23, 2004 at 18:28:23:

You are basically saying all is OK and yet it does not run correctly. You will have to change your approach to fix it. Do a compression test and compare to specs. If compression is OK, the problem is ignition or carburetion. You you don"t say what"s been done to the ignition if anything. Myself, I don"t usually try to pin-point the problem to fix these engines. I just do a complete tune-up. I would probably install new points, condensor, and spark plug to start with if this has not been done. Points gap must be correct as that controls the ignition timing.
You could upgrade to a magnetic ignition pick-up in lieu of points. Kits are available. The coil is still suspect if it is original and as old as that tractor. But hold on that for now if the spark is good and go back to the carb. You say you"ve been thru the carb but don"t say what you"ve done. Strip the carb completely removing all the jets. Soak all parts 24 hrs in Berryman Chem-Dip carb and parts cleaner. I like Berrymans because it"s good stuff. I think it"s $15 for a galllon soaker. The cheap stuff doesn"t work. Wash all the parts with hot water and detergent after soaking. Rinse in hot water and blow out all orifices with compressed air. Set the low speed (air) adjustment at 1 turn off seat. Set high speed jet at 1 turn off seat. Start and run til up to temperature. Set throttle idle stop to run slowly. Adjust air screw in/out for best running. (in is richer, out is leaner, this is opposite of high speed screw.) Open the throttle lever to wide open (governed speed) and adjust the high speed screw for best running. Out on this screw makes a richer mixture. If all this works it should be fixed. If none of this works, replace the coil. If that doesn"t work, replace the carb. Most cases if the carb is not damaged it is just a simple matter that it is not clean.
You need a good soak and compressed air to clean it.





Follow Ups:




Post a Followup

:
:

Subject:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy