Posted by Rock2000 on March 21, 2015 at 11:34:00 from (32.210.159.1):
I did a rebuild on our H about a year ago and it seemed to be running well. I had it out today, but it sounded a little different, and there was a hint of a funny smell. I figured it was time for an oil change anyway, but when I drained the oil it was the horrible mix.
Is there anything on an H that could leak coolant into the oil besides the head gasket, and I suppose a cracked head/block somewhere? I'm thinking of blindly replacing the head gasket and see what happens. I'm trying not to contemplate a cracked core part. If it was a headgasket, would there be any visible indication when I take it off?
When I did the rebuild, I re-torqued the head after about 2 hours of use. The only odd thing to me during the build was that two sleeves were very loose on install. I coated them a bit with the Loctite sleeve retainer, and all the posts said the head gasket would hold them down once torqued anyway, although there seemed to be very little overlap of the gasket and sleeve. Other than that, I don't know what I could have done wrong.
Any advice that doesn't involve another rebuild? Can I run clean oil through for a bit and then change it and have it flushed? Should I check bearings somehow? The rods would be easy to get to, but I'd rather not deal with the mains.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
