Posted by pete 23 on March 22, 2015 at 16:04:39 from (50.33.12.37):
In Reply to: Re: H, water in oil posted by Rock2000 on March 21, 2015 at 14:39:53:
I always like to run a cylinder leakage test. I really dislike pulling a head and then not seeing a problem. If I don't find a leak that way, I pressurize the radiator or just pull pan without pressurizing and let it stand for a while and check underneath for leaks. I will say this. You feel the head gasket did not contact much of the sleeve and what I have seen over the years is some have used a Super H head gasket on an H and that even allowed the sleeve to work it's way past the gasket and move up and down. Another thing. Many aftermarket sleeves have a flange that is too thick and protrude over the block too much. Book say up to .006 is ok. To me that is pushing it too much and I have seen .008. That did not work out well for the guy. I never get too excited about a loose fitting sleeve but I do measure bores and select the best fit for that hole. Some guys run a hone to clean the block and that is a no no. I have found a wire brush on a drill does a real good job and does not remove any metal. You can try first like one suggested, take plug out and let stand for some time and see if any coolant comes out of plug hole.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.