Posted by pete 23 on March 15, 2015 at 17:15:07 from (50.33.12.37):
In Reply to: 1586 updates posted by Moline_guy on March 15, 2015 at 12:29:25:
The bearings you are talking about are originally ball bearings. One on the differential output shaft which drives the planetary input gear and one on that shaft that gear rides on. They are bower flat roller bearings that were used in some of the large four wheel drive tractors. No 2+2 ever used the planetary rear axle drive that was used on the 15 series tractors. Lot of mix up about that. The 70 series 2+2 used rear axle like the 50 series which is totally different than a 15 series. We replaced a lot of those bearings because we had a customer with a major failure of that ball bearing that busted the adaptor housing so it kind of spooked out a lot of customers with 66 and 86 in the 15 series of tractors. There is a service bulletin some where that put us onto this as an option to the ball bearings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.