Posted by Moline_guy on March 15, 2015 at 12:29:25 from (216.249.226.191):
I am sending my 1586 to a local father son shop to have a new TA, clutch, rear seal, input shaft and gears, and throwout bearing put in. They have done a lot of IH TA's over the years but few if any rear ends on the 1586. I remember reading over on Red power there was some updates to the final drives to make them last longer. For some reason I can't get logged in or set up a new account over there and I can't find it in there archives. I thought the update consisted of putting in bearings from a the newer type 2+2 in the final drive but I don't know which bearings they are talking about. Would appreciate any information on what else should be done as long as it is going to be tore down this far. I bought the tractor with a little over 3000 hours about 8years ago and is close to 6000 hours now. Engine was sleeved when I got it, but as far as I know the drive train has not been worked on. Tractor runs and shifts good, but low side of TA has been slipping this past year. I use it as a spare loader tractor, planting, haying and silage cutting. Thanks for any information.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
