Posted by gqjoe on February 04, 2015 at 22:28:00 from (173.210.167.202):
I wanted to post an update on my progress with my 17gpm pump upgrade in my 606. I installed the new pump and suction tube and it went together very easily. On the filter side input on my filter extender kit but noticed that the filter had a large opening on the exterior side. After some research I found out that I needed to order a filter bypass valve before I put the filter, extension and lid on the tractor. I did that and that side went together very nicely too! Also when putting on a dry pump I filled it with oil through the hole where the filter attaches until it came out before I put the filter in. It started and now it sounds way way louder than it did before. It whines and it seems to get a little quieter when I steer left or right. The whining also seems to be coming not from the pump below which I would say indicates gears clashing but it's coming from the flow divider valve area. I'm hoping I could get some help with this yet as to what I should check out or test.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.