Posted by Dave in Southern IL on December 04, 2014 at 10:40:55 from (50.122.58.67):
I have a 784 that I move round bales with. My bale mover (3 pt hitch bale forks) has a hydraulic cylinder on it to lift the forks higher than possible with the 3 pt hitch. My problem is that when I set the top link length so I can slide the forks under the bale, they are tilted down enough that the bales will slide off of the forks if on a grade. I would like to use a small cylinder for a top link so I can tilt the forks up after I raise the bale with the 3 pt. The problem is that I only have one remote. Can I put a "T" in the hydraulic lines for the cylinder on the bale mover so when I raise the bale up the "top link" cylinder will contract and tilt the forks up in the back to prevent the bale from sliding off? Then when I set the bale down to feed when I lower the forks with the bale mover cylinder will the "top link" cylinder extend so I can pull away from the bale without it dragging along? I know what I really need is another remote but they are kind of expensive. Any thoughts would be appreciated. Thanks, Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
