Three plugs to drain and if you feel really ambitious, take that T shaped cover off bottom of TA housing. It usually collects a lot of sludge. You can unhook the power steering return line and run it into a bucket while turn steering wheel to eliminate some more gunky oil. If double action cylinder on loader and or bucket I take return hose off with cyl fully collapsed and purge that oil also. Hitch cyl also if fast hitch. This will help get more crud out, but you will still have some. Far as bull pinions, lot of them get switched side to side for least amount of wear on driving side. If you do swap gears make sure gears are same angle of teeth as that is what was changed on the gears when updating packages were installed. A few tractors did not get the updates but the ones that did would still wear out those gears if used hard over time. Does it have flat roller bearings on bull pinions and tapered roller bearings on the differential. The flat rollers were not in original change but added later during another bearing upgrade package or just a repair.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.