Posted by mjp9348 on August 17, 2014 at 14:18:37 from (50.129.238.21):
In Reply to: Re: Farmall wont start posted by Bill In NJ on August 17, 2014 at 10:37:00:
Hi Bill , I have a gas in the bowl , BUT I did Not Adjust the jet screws according to what you are saying . I just screwed them in per the directions to this carb kit , only thing it mentioned was where the float needs to be set , the travel distance which is 7/8 fuel level and 1 27/32 height of float from upper body .
All the jets are clean , even the screen is clean . But what I did notice when I did do the carb rebuild was the idle metering jet was almost flush with the 2 halves versus mine which I screwed all the way down. The discharger nozzle and nut as the directions say is just put in and tighten outside of carb nut .. but I am going to give this a try and go from there , as well as follow the other comments about inspecting the gap on the rockers .. I think I am getting closer to figuring this thing out , but who knows .. As far as the timing goes , It might be off , I am not sure , this tractor has all the original parts until now .. New coil and pistons and sleeves and carb rebuild . still has the original paint and decals not a single dent in the covers , just a little dent in the front grill cross support , nothing that cant be popped out .. I don't think it has ran in 10 years tho ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
