Posted by John T on August 12, 2014 at 12:50:37 from (216.249.72.121):
In Reply to: Delco 10si hookup help. posted by PretendFarmer on August 12, 2014 at 11:06:50:
In order to prevent the tractor from running on even if you turn off the ignition, in the "excitation circuit" from a hot when IGN on source (Ign switches IGN output or coil input) to the alternators small No 1 side terminal, some use a diode, but I prefer EITHER a 10 ohm 5 watt resistor or an Idiot Light (as Bob M noted) because it provides some degree of current limiting, its not polarity sensitive like a diode is, and is cheap, easy and simpler to wire.
The small No 2 terminal is the "voltage sense" and I usually just jump wire that to the big main alternator output stud.
The big main output I use No 10 wire up to an ammeter if it has one or else to the hot + ungrounded battery post, often via where the big battery cable attaches to a starter switch or solenoid input.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.