Posted by Rick Remmert on July 03, 2014 at 16:50:12 from (68.103.4.23):
In Reply to: Quick question posted by Parmenion on July 03, 2014 at 08:17:41:
I just spent the last 8 hours mowing with my 5' rotary mower on my Super C with a 3 point conversion. As said below, you have to run a overriding clutch unless you have a death wish. When it up in the air, the front gets a little light. I have 2 45# wheel weights up front. I run in 2nd gear in CRP grass that is as tall as the gas tank. I have done a lot of engine work. You have to have "rake" in the mower deck so you are not mowing everything twice. I have mine adjusted 4" higher in the back than in front. The cut weeds coming out the back should look like a windrow, nice and smooth on top. If it is ruffled on top, the back is to low. It saves a lot of horsepower.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
