I am in Nova Scotia, Canada. I have a bit of a theory about tractors in these parts that being that most of the farms here are small and fairly poor (or at least they were) and we have very few pre-WW2 tractors in this part of the world. Most of the older tractors around here are from the early forties and the following 15 years. Not many hundred series, fifty series, or sixty series though. It seems that most of the tractors were made to serve long past their normal working life and were often fixed in the cheapest way. Also most tractors here saw double duty on the farm and in the woods so straight sheet metal is almost non-existant. Add to that a very damp climate with frequent temperature swings and stuff gets rusty in a hurry.
I have a center section from a 300 utility in the yard and at some point the starter must have hung up, someone took a drill and drilled a series of holes in a square about 3" big. They then smashed out the chunk of casting in the middle, put a piece of aluminum plate over it, and several coats of blue paint over the whole tractor, didn't find that until it got home. The last Super M I had when the clutch started to go south and wouldn't release properly they cut the adjuster rod and welded a bolt into the middle until the fingers wore off the clutch, the throwout bearing broke its carrier tube, and the tractor would go no further.
Abused tractors are the norm around here, sometimes they're easy to spot, sometimes they hide a little better and I've been bitten before. I don't have any objections to that tractor (I think it'd look great in the shed) but just want to make sure I don't overlook something because it appears to be in good shape. Thanks, Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
