Posted by mazemeister on March 14, 2014 at 15:02:39 from (173.3.242.74):
In Reply to: 1486 range stuck posted by idahofarmer on March 14, 2014 at 14:43:51:
pull up the floor mat and remove the rectangular plate of steel so you can get at the top of the trans. the range trans is back under the seat so you got to kinda reach back there with something, but there are 2 shafts w/ arms on the top. if you wiggle the range lever, you'll see which two it tries to move. what you need to do is put the lever in neutral but over toward rev/park, then reach back there to the high/low shaft and put it manually in neutral. then you're all set.
it helps to make sure you're completely stopped before taking it out of gear and make sure you shift fore/back to neutral, side to side as necessary, then fore/back to what you want, instead of doing more of a U shaped motion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.