Posted by gene bender on March 11, 2014 at 13:40:10 from (207.177.56.213):
In Reply to: super c frontloader posted by steve1243 on March 10, 2014 at 15:10:14:
The C wasnt realy built for that capacity but with careful driving you could carry them some just dont go high as the rear wheels wont have very good traction. Your lift cacapity will depend on the dia of the cycls. Long time ago i built one for my B I esed 1/2 x4 flaat bar from the front pedestal to the bell housing by the starter to support it from splitting. Used 2x4 tube for the upright off the flat bar and 2x2 tube for the frame. Pull the two pins from the cycls and two more from the uprights and loader is off leave the cycls on the tractor. Front of the cycl lays on a bracket by the steering pedestal 2wts on each rear wheel. Have two forks and they can be removed for the blade snow removal. But moving round bales with a C pretty risky.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.