Posted by WellWorn on February 23, 2014 at 18:17:23 from (75.213.114.54):
In Reply to: Super A Plow posted by Brutalfly on February 23, 2014 at 09:09:26:
I'm not sure what your mean by "and neither are the arms that go to the hydros".
Probably the most common plow for the SA was the #93, single bottom. I have one, and it works quite well. Bought it a few years ago for $75.
Unfortunately, besides not having a way to get a picture uploaded, the plow is currently buried in a couple feet of snow. I may not even see it for another month.
Yes, you will need both hydraulic rams working (IH's famous "Touch Control") the right lever lifts or lowers the front of the plow beam to adjust 'draft' (amount of downward 'pull' from the plow point), and the left lever raises and lowers the back of the plow beam for depth of furrow. Once you have it turning the furrow nicely, there are 'thumb screw stops' for the TC levers, so the settings are repeatable.
The front link for the plow is an adjustable rod that bolts to the U shaped draw bar turned to face the front of the tractor (comes to just forward of the rear tires). The front of the plow beam bolts there too. The back of the plow beam is suspended by a chain and special "J" link that hooks to the right rear lift arm.
I know it probably sounds Greek, but if you could see it set up, it would make perfect sense.
Probably someone else has pictures. If you would like them, just ask.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
