Posted by Janicholson on December 18, 2013 at 17:35:15 from (74.60.94.18):
In Reply to: Re: Coolant bypass posted by pete 23 on December 17, 2013 at 16:25:10:
Rethinking the issue. If the common connection to the engine side of the T-stat is the block through the big rear hole, and the hose connection on the bottom, the circulating water would still be able to get to the radiator (undesirable in large quantities for warmup) if the hose port was restricted. It would also restrict block flow to even out the warming up coolant. What I suggested prevents coolant from getting to the other side of the T-stat in large quantities, where it is cooled too much and never allows the engine temp to be "normal". The best solution (posted above by another contributor) is to use a stainless steel sheet metal blocking restrictor plate between the halves of the housing limiting the flow to the radiator to 3/8. Respectfully, Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.