Posted by pete 23 on December 17, 2013 at 16:25:10 from (74.33.91.156):
In Reply to: Coolant bypass posted by notjustair on December 17, 2013 at 15:17:05:
I would put a plug in it and then you can drill a hole in plug to size you want. Probably start with about a 1/4 inch hole. When you are doing this , take the thermostat housing off. Put a garden hose in the outlet where it connects to radiator. See how much water flows on through. That is most likely the reason your engines does not warm up. You put a lot of water past most of those thermostats because the housing is corroded out inside. You will notice all newer engines that use the tube style thermostat also have a seal in the thermostat housing to allow only the amount of coolant to flow that can go through the bypass hole in thermostat. Some of those holes are also too large and can be soldered shut and then drilled smaller.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.