Posted by arkie on October 23, 2013 at 18:58:54 from (173.202.60.75):
Hello to all! As the subject indicates I have a 560d that will only start by pulling. It will start after pulling @ 100' and smoke like it's running rich.Tractor won't start turning over even with 2 hot 12 volt batteries,and brand new glow plugs. The glow plug meter will peg out and wiring has been replaced correctly. I know the tractor was timed correctly at 3 degree btdc on compression stroke on #1 cylinder,however the injector pump was timed using air in #1 port on the injector pump as the scribe mark in timing window is nonexistent.I know this will indicate start of injection time and the pump should be timed at the end of injection time but I have tried to educated guess where that is.Is there some way to put air on #1 port and time the tractor at something different than 3 degrees btdc to allow for end of injection timing? I'm at a loss for a direction to go with this issue.I've received plenty of help from this site and
appreciated every bit of it.Feels like the tractor is pretty close to where it needs to be,but the two of us need a little more help.As always all help is appreciated. ARKIE
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
