Posted by Tom Fleming on October 05, 2013 at 03:55:27 from (67.20.233.75):
In Reply to: Farmall B Puller posted by Fred Goodrich on October 03, 2013 at 12:20:04:
On the A, B, BN design, the drawbar attaches to the final drive housings, so no significant stress is placed on the engine/transmission/torque tube while pulling a load from the drawbar.
All of the pulls I participate in here in western PA start at 2500 and go up, usually 500 lb increments, although a couple do 1000 lb increments. The problem you will run into is that for the weight/HP ratio, you will end up being in higher weight classes to keep from losing traction. Those higher weight classes also tend to have the higher HP. This summer , I pulled my F30 HAN in the 5500 class. I stayed with everything that competed, and I always ran out of traction. When I tried the 6500, I didn't run out of traction, but got outclassed on the HP.
Power to weight ratio is key, and a properly tuned C-113 will surprise you at what it can do. I have a BN that I use to skid logs out of the woods for firewood......many times I came out of the woods steering with the brakes because the front wheels were off the ground.....as I posted before is the light front end is the challenge. For the size and weight, the A, B, BN design will do a surprising amount of work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
