|
Farmall & IHC Tractors Discussion Board |
Re: Mounting aux. hyd. pump on Int'l. 404
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john m on November 19, 2000 at 18:41:42 from (63.53.140.179):
In Reply to: Mounting aux. hyd. pump on Int'l. 404 posted by Mark Correll on September 01, 2000 at 17:49:02:
the link attached shows a loader atached to my ih404. i used the bumper to weld a 4 inch cahnnel so i could set the pump. very easy job. pump is connected to crank by use of 1/2 " shaft,woodruff keys and a fibre washer. removal of loader is with 4 pins. takes about 20 minutes to un do or install. shaft splits at fiber washer by a woodruf key. lines up automaticaly. you wouldn't believe it was so easy. loader is an antique off of an early harry ferguson so length of rear lower arms was extended. i also added 16 " on each side to make loader 73 " wide. works great. have been using this since 1972. tractor still purrs. 1600 hours showing on hr meter.needed to add ballast so i added 300 lbs to 3 pt fork lift type adapter. works better than the wheel weights i had originally used. (weight is a small old cast iron boiler some one scrapped)if link doenst work go to photo gallery and under tractor photos find ih404 just posted
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
