Posted by kopeck on May 20, 2013 at 18:10:22 from (69.50.52.188):
In Reply to: Carb for a BN posted by molzf on May 20, 2013 at 17:16:07:
You might be surprised at what you can do with that Zenith.
I bought a "parts" Zenith off eBay for a few bucks. It looked like it was buried out back for years, wow was it a mess.
Pulled it a part, used heat to make sure all the brass pieces came out OK, soaked the heck out of it in carb cleaner and once I had all the gunk taken care off I soaked it in Evapo Rust and then chased all the circuits with drill bits (by hand).
Soaked it in carb cleaner again then blew it out with compressed air.
It sounds like a lot of work but really it's just a 20 minutes a shot for a few nights.
I have a BN with a Marvel as well, they both work well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.