Posted by pete 23 on March 03, 2013 at 16:28:29 from (74.47.40.242):
In Reply to: Re: Hydro 86 posted by Erik Dekeyser on March 03, 2013 at 15:59:43:
It is a place to start because you are then eleminating external problems, except in your case you want to be doubly sure the SR lever is fully moving the drive control spool when you move it side to side. There is an adjustment on that to get equal movement both ways. Some times just a loose quadrant will give you a no drive, stop drive or uneven speed control. I would check that part out first. Also, does it go normal in reverse. If it goes faster than normal the hydrostatic motor may be operating in the fast position all the time. The blue line on the quadrant is when the pump has reached it's maximum tilt for higher speed and from that point the motor starts to decrease it's tilt for more speed. A hydro is quite simple in theory, except about a thousand different things happen to them, mostly minor but sometimes hard to pin down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.