Farmall & IHC Tractors Discussion Board |
Re: Grandad's 51 H and it's new owner
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on November 06, 2000 at 06:44:52 from (207.254.53.124):
In Reply to: Grandad's 51 H and it's new owner posted by cdprimm on November 05, 2000 at 22:00:41:
Hi CD, Welcome to the board. Great snag on Grampa's H. There's alot of info here and from really experenced people. On the nose, I would rework the one you have. It's not that hard and even if you don't have any experience on doing sheetmetal(SM) work you will have when you get finished in about 6 hours upon the worst condition and about 3hrs on your next one!! Take a body and fender hammer and dollie, buy these at any cheap place for about $35 a set like Northern Tools, a 1/2" thick metal working bench would be great or anvil, start dinging with the pointed end of the hammer, don't hit too hard but just hard enough to straighten the SM, don't try and straighten in all in one blow, take small areas at a time with going over the same area several times, The metals going to streach some but don't worry, after you get it close then take a oxy/actn tourch and heat round spots on the SM bubbles to about and orange heat color then cool quickly with a water soaked rag and the bubbles will shrink away leaving a straight piece. You might even split some SM but just "gas weld" not Mig meld the splits and holes. Baling wire makes the best filler wire there is for this and back up weld area with thick copper to keep weld bleed thru down. If you take your time and not rush you will not need body filler when done. Try it on a piece of scrap SM first and you'll see what I mean. And please wear ear plugs! Have Fun, T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|