Posted by ihman73 on December 08, 2012 at 08:24:19 from (38.114.76.49):
In Reply to: 1086 Hydrualics posted by CumminsMan on December 07, 2012 at 09:05:25:
The 86 series with the open center system aren't really intended to run motors. The primary issue is during continuous motor use the oil routing is different then the 06-66 series tractors, the mcv pump charge circuit is starved of oil when a continuous demand is placed on the remotes. For non continuous use on a feed wagon or bale processor conveyor when feeding you should be fine but continuous use such as a planter vac motor or sprayer pump there is a way to make it work. Ace made a kit for using a hydraulic spray pump on these tractors without using the remotes(power beyond). The installation guide shows where to plumb a motor return to eliminate this problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.