Posted by John T on December 01, 2012 at 05:23:09 from (216.249.82.117):
In Reply to: change field coil posted by GP Hansen on November 30, 2012 at 19:20:21:
Those big screws that hold the field coil iron pole shoes in place seem to really FREEZE IN PLACE. Ive seen the local genny shops here take a big hammer and give the gennys outer case around where those huge screws are A GOOD HARD SHARP RAP and then use a hammer driven big impact screwdriver and they come right out........ Its gonna take a good cleaning and solder job (then heat shrink) to make the connections and where the 2 windings splice in the middle keep that tucked away and safe. When doing all this Id have the commutator turned and undercut if needed,,,,,,,,Install new brushes if needed,,,,,,,,Install bushings if needed.....Insure good grounds on both the genny and VR,,,,,,Polarize the genny prior to start up
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.