Farmall & IHC Tractors Discussion Board |
Re: Busted Gears
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on October 21, 2000 at 19:32:26 from (172.159.168.148):
In Reply to: Busted Gears posted by Jim on October 21, 2000 at 19:10:04:
Jim - I'm finishing up a similar repair to my Super M. In my case the nut that holds the gear on the end of the cam shaft unscrewed and fell off. This resulted in the cam gear slowly flopping itself to death inside the gear cover. There was lots of metal in the bottom of the timing gear cover, but other than chipping a couple of the other gears, seemed to have caused no harm to the rest of the motor. A new gear has been purchased and installed and I'm in the process of putting the tractor back together. Link below has some photos of the work in process. Suggest at a minimum you get the I&T manual for the letter series Farmall (#IH-8)- it's about $20. Also highly recommend buying a repro parts catalog for your model. That will run $30 or so at Binder Books. You'll find it's worth it's weight in gold for repairs like this. Good luck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|