Posted by DanMD on October 03, 2012 at 18:46:07 from (184.158.79.230):
I have a question in regards to what I believe is a Keystone kit on my Grandfathers Super M. He had the kit installed as a novelty for running up and down the road. He doesn't pull it or work it from what I understand. He has blown the motor 2 times and after the 2nd time, he had the best engine guy in the area rebuild it to the tune of 5K. After the rebuild he gave the tractor away. I asked him how it was doing with its new owner and he told me the engine builder broke it in on the dyno and said all was well. After the break in it started blowing white smoke and hitting on only 2 cylinders on a road trip. My Grandfather doesn't have a computer and asked me to call the manufacturer and ask their thoughts. I haven't called them as I know very little about the whole tractor. I thought maybe some of you might know what could be causing this. I am in no way bashing Keystone as I have never heard anything bad about their product or talked to them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
