Posted by Bob3 Martin on September 09, 2012 at 12:39:08 from (71.7.75.192):
In Reply to: Re: 806 RD pump posted by pete 23 on September 08, 2012 at 22:45:34:
Just thought I"d add this note in case someone comes up with one of these old dinosaurs with a similar problem.
The bleed knob/stem I had the leak at is in good shape now.
This is what I did with Pete"s expertise.
At the rear of the injection pump is the primary pump Pete said I need to get into to access a pin to remove the bleed stem to replace the leaking "0" ring. The little 1/4 serrated head bolts hold the end cap on and the two allen bolts hold everything to the injection pump.
The little release pin Pete mentioned is down at the bottom of the casting and goes through to a ridge on the stem with a flat on it. If you just loosen all the end bolts about 3/8 inch and pull the end cap back from the main body with the bolts left in place you can turn the bleed stem back and forth and force the retainer pin away from the stem, then pull the stem out and replace the "0" ring. Then just tighten it all back down and you"re ready to go.
The best way to fix it is like Tractor Vet said - take it to a pump guy that knows what he"s doing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.