Posted by wisbaker on August 14, 2012 at 15:59:08 from (207.118.144.43):
In Reply to: M Farmall Front end posted by Lynn Scrogum on August 14, 2012 at 13:14:00:
The M&W clutch is installed on one of the rear axles when you to de-clutch the axle all the power for the drive gets routed to the de-clutched axle and tractor momentum stops. It doesn't allow you to change gears or anything but you can start and stop the tractor say like if the baler you're pulling loads up and you need to stop feeding it. It may seem like a Rube Goldberg set up but it's actually a similar set up like Allis Chalmers used from the factory. You can't convert an old letter series Farmall to independent PTO unless you change out everything from the flywheel back (Clutch, trans and rear end. If you really need IPTO trade up to a Super MTA (M-torque amplifier) or a number series (240,300,350,340,400,450,560) that already has it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.