Posted by rhtx55 on July 21, 2012 at 21:29:01 from (207.119.61.27):
In Reply to: Super C question posted by Brett Helmkamp on July 21, 2012 at 14:50:54:
You might consider using 10 ga wire on any wire you replace, this will offer less resistance on a 6 volt system, fewer problems down the road.
Some may find the smaller battery cables will do, but on a 6 volt system the less resistance the better, hence the larger copper "double ought" battery cables. Use a voltmeter & check the generator output when running, get the battery charged fully, then start trouble shooting the charging system. The generator & starter are easily rebuilt, but finding the man with enough experience to rebuild them correctly can sometimes take a bit of research, usually new brushes & bearings in the genny, new brushes & bearings & starter drive for the starter, and you will be good to go. Do not pitch your original voltage regulator, use a replacement to "get it going", if your research some vintage car websites they will explain how to properly clean the contacts, set the air gaps & get you old voltage regulator working as it should. Not much ever goes wrong with them, they usually burn the contacts & quit making connections to keep the battery charged without over charging.
The charging systems on these tractors were designed with daily use in mind, it is much harder on them to just sit. A battery tender is a good idea, it uses a low "trickle charge" to keep the battery amperage up.
The trick is not to let the battery get so low it loses the ability to recharge properly. I usually charge mine up with one every two to three weeks of just sitting. It sometimes takes it overnight to charge fully.
Keeping the engine tuned to start right up after a turn or two helps immensely, proper carb & ignition timing go a lot further in having one start quickly without putting such a strain on the battery or starter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
