It could be that the splines are worn that engage for 5th gear or it could be that the detent ball is missing or the spring is broken, which would be much cheaper fixes. You may want to start by dropping the belly pump and removing the input shaft, U joint and upper constant mesh gear assembly. This would give you a chance to look at the gears that make 5th and see what kind of shape they are in. The top cover is not too bad of a job, just remove the belt pulley drive if so equipped, the gas tank, the seat, unbolt the steering column from the top cover and hoist the whole thing up a bit in the air if you don't want to have to disconnect everything. The top cover is not that heavy, maybe 100 pounds at a guess. If it sticks try tapping in hardwood wedges in the crack between the rear casting and the cover, try not to whack the "ears" of the top cover too much with a hammer as they will break off pretty easily. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.