Posted by TJV on June 20, 2012 at 08:23:19 from (67.230.241.17):
In Reply to: Torque amplifier posted by Bill in IL on June 20, 2012 at 06:02:51:
Depending on what you will use the tractor for if it is a show/parade piece with little to no workout i will opt. to rebuild the ta myself. If the surfaces on the ramp are fairly smooth and not chewed up you can put new rollers the brass push pins the put pressure on the rollers, the springs that push the pins and the rubber plugs the hold the springs in new, all those parts were available from case ih yet this past winter. Along with that there is a couple of oil seals that I replace when in there along with the ta clutch throw out bearing. I think it was less than 200 in parts or at least the last time I did it is was. If you plan on pulling the tractor hard over the next few years I might consider a rebuilt one. I have had good luck rebuilding it myself (and saving $'s) and if you like a little bit of a challenge its not that bad but i highly reccomend getting an I&T book for guidence and adjustment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.