Posted by D Slater on June 19, 2012 at 07:36:08 from (184.15.43.82):
In Reply to: Re: governer? posted by farmall h 1939 on June 19, 2012 at 05:21:14:
Pictures of IH and power gov. H and one M power gov tube and small levers. H and M governor upper housings. IH and H P.G. and M linkage.
All power governors are not alike but you probably have something like the pictures. Depends how much work you want to do. If you don't have the power governor tube and shaft to the carb. Little lever from the end of the M tube needs put on the H tube. Sometimes shortening the tube and shaft is needed to line up and sometimes a new pin hole drilled. Need H upper housing put on the M housing. Need shorter threaded rod to go between the heim joints. Need governor drive gear changed. Power governor rear weight shaft bushing is made for a smaller diameter shaft on some so the power gov. shaft needs to stay with its housing if so.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.