Posted by Rootsy on June 01, 2012 at 19:55:29 from (174.124.182.157):
In Reply to: IH 56 Planter Skips posted by Jeff Wenner on May 31, 2012 at 19:28:19:
I gave up planting Sh2 seed with my 455 (predecessor to the 56) drill plate planter. The stuff is so small you could not get a corn plate small enough to singulate and sorghum plates needed to be opened up significantly. Even then the seed is so inconsistent in size and shape, even when graded, that it can be a crap shoot.
I replaced it with a lightly used 400 Cyclo and I am MUCH happier... At least for sweet corn.
The plate planters are pretty simple... Ground driven so if the tires turn the main drill shaft and the gear teeth are intact and the clutches are engaged to turn the drill shafts to the seed plate drives then the only real issue is probably inconsistent seed size with a plate that is a little "too tight". If it is a hill drop you have to worry bout the accumulator assembly also. These planters were pretty simple and I always kept mine well greased, including the bevel gears...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.