Posted by gab on May 15, 2012 at 18:08:38 from (50.44.11.139):
Do you need to pull the pump out of the liftall and then stick a bar in the gears to get the nut off the shaft to repl the seal. The pict. in the I&T manual looks like you stick a small bar in the gears through a hole in the case. Also I noticed on another Super M that the draw bar axle mounts are turned over from the way mine are which would raise the drawbar a couple inchs probably. The operators manual pictures and the parts book shows the brkts. flipped from the way they are on my tractor. I can tell by the pitting on the top eye bolts and lack off it on the bottom bolts that this is probably the way it always was and did'nt see any thing in the op manual about turning the brkts. for any reason. So which way should they be .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.