Do you need to pull the pump out of the liftall and then stick a bar in the gears to get the nut off the shaft to repl the seal. The pict. in the I&T manual looks like you stick a small bar in the gears through a hole in the case.
Also I noticed on another Super M that the draw bar axle mounts are turned over from the way mine are which would raise the drawbar a couple inchs probably. The operators manual pictures and the parts book shows the brkts. flipped from the way they are on my tractor. I can tell by the pitting on the top eye bolts and lack off it on the bottom bolts that this is probably the way it always was and did'nt see any thing in the op manual about turning the brkts. for any reason. So which way should they be .
Also I noticed on another Super M that the draw bar axle mounts are turned over from the way mine are which would raise the drawbar a couple inchs probably. The operators manual pictures and the parts book shows the brkts. flipped from the way they are on my tractor. I can tell by the pitting on the top eye bolts and lack off it on the bottom bolts that this is probably the way it always was and did'nt see any thing in the op manual about turning the brkts. for any reason. So which way should they be .