Posted by PRTZMAN55 on April 17, 2012 at 07:09:15 from (65.79.254.50):
Morning All, A while back I asked how to replace the push button switch in dash on a 1967 IH Cub. Its not really easy as you need to remove dash panel from gas tank and torque tube and slide it toward sterring wheel.
i didnt disconnect the accl or choke rods as it slides back just enough to get in with tools. I was suprised every thing came loose with no problem with a little PB Blaster. Only real problem was the switch I crossed the IH number to my store number and it would not fit the hole button was too large. I ordered one From IH and it was the very same thing with my part number. after a little grinding it went in and hooked up every thing like it cane off. Went to fire it up still nothing like it was ????? So it decided to replace battery terminals the cables if need be ,put a new one on the positive cable , hooked up every thing and she fired right up, Wonderful to here her running again took her for a quick run around the yard , I think she liked it too. Harry
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
