Posted by BoonvilleKid on April 12, 2012 at 06:59:11 from (24.206.167.119):
I've never used or even seen any equipment mounted on a FastHitch system. So I bought a FastHitch system and a plow for my SC as I wanted to give it a try. After installing the system and hooking up the plow I gave it a trial in a back field. The lift system works fine but the touch control doesn't work so well. The biggest problem I had was leveling the plow from side to side. The flat bar is in the back hole of the rockerarm. The flat bar does not line up well with the inside rockshaft. I don't see any way to adjust the flat-bar inward for better alignment. I does work, it doesn't bind, but it could be better. The major problem I have is leveling the plow from side to side. Pushing the touch control lever all the way down causes the plow to be very high on the right side. Pushing the touch control lever fully upward causes the plow to be nearly level but it's still a little high on the right side. The leveling rod that is controlled by the flat bar attaches to each side of the lifting arms. The attachment device, between the leveling rod and the lift arms has two holes with pull-out pins. This is the only place on the whole system that I can see would be a place of adjustment of the side-to-side adjustment. I pulled the pin on the left side and relocated the pin to the other hole. This may have helped a little, but it's still not really level. So, I'm confused. How is the system set up where it is initially level so the touch control lever can be used to raise or lower the plow from side to side?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
